Conversation
Snacks
snacks
It's not warping like the pla, just not sticking to the bed and all of a sudden gets knocked off, weird
1
0
0
mia (developer mode)
mia@shrimptest.0x0.st@snacks try some of fiberlogy’s transparent pctg. but do not heat the bed unless you want it to fuse with the part
not kidding, it’s the stickiest shit i’ve ever printed with. petg is nothing in comparison. you can extrude it from 15cm above the bed and the noodle will stick to it
2
0
1
@snacks you also need to go relatively slow with it (as in movement speed, not voluflow) because it clings to the nozzle
0
0
0
Snacks
snacks
@mia i haven't even properly cleaned the plate before tbh did that and added some gluestick nkw. This is specifically a test print to figure out how the nylon shrinks, so using a different filament isn'r gonna cut it (fun fact, realized after ordering that petg might be better for my application but we, nylon is good and fibrologies cheapest is cheaper than most pla)
2
0
1
mia (developer mode)
mia@shrimptest.0x0.st@snacks yeah fiberlogy tends to be pricier but i can vouch for the filament. huge fan of their ASA in particular
0
0
1