Conversation
@snacks im literally coping and seething right now
1
0
1
@snacks opened prusa slicer, checked my regular preset for printing that x carriage i wanted to modify, 3 and a half hours
2
0
1
@snacks with petg too, odds are you're doing asa again
1
0
0
@coolbean pla, it's raining so i can't put i outside and pla has longer fatigue life which i need for this
1
0
1
@coolbean don't print 3d printer parts that aren't just visual in pla, it creeps like crazy
2
0
0
@snacks im not planning to this was just for comparison purposes. this is like the least stupid stl ive got rn
1
0
1
@snacks although i will admit i do want to print this itty bitty direct drive extruder adapter asap so that one might be pla but its on the other side of the x carriage so itll probably be fine? a girl can dream
1
0
0
@coolbean the adapter might be fine, it should just be under compression.
1
0
1
@snacks its got some funky twisting forces that i hadnt really been thinking about before
i think ive got an idea for how to orientate it while slicing that should minimise this at the cost of adding supports
i think ive got an idea for how to orientate it while slicing that should minimise this at the cost of adding supports
0
0
1
@snacks im trying to figure out why my perimeters are so fucking slow currently cause 1mm³/s is literally ridiculous
2
0
1
@snacks dare i say taking the pish
0
0
0
@coolbean i've set my whole first layer pretty slow but idk what that ends up in flow rate
1
0
1
@snacks see but the first layer is supposed to be slow for maximum adhesion this is every perimeter on every layer for me
1
0
1
@snacks that too but the inner perimeters arent much better!
3
0
0
@coolbean ok, is something printing as fast as you want?
1
0
0
@snacks maybe it counts em as small perimeters. those are set to the same speed as outer perimeters
0
0
1
@snacks idk, slicer estimates be weird and i havent set it up properly yet anyway
1
0
0
@coolbean that's also what you wanna print fastest because it don't matter a lot
1
0
1
@coolbean figuring out your slicer settings is gonna take a lot of time yeah
1
0
1
1
0
0
@snacks speed i mean. settings for inner are literally double of outer and identical to infill
0
0
1
1
0
2
1
0
2
1
0
2
1
0
1
1
0
0
1
0
0
@mia @snacks somehow this fixed the weird fluctuations in speed as well where like every second layer was super slow and now its still 30mm/s on the perimeters which is still short of what i set the perimeter speeds to but its added up to a bit over half an hour saved which is ok. gonna have to dial in the speed more at a later point (by default x and y have the same acceleration and speed limits which is silly)
1
0
1
1
0
2
0
0
0